Home     |     About Us     |     Culture     |     Products     |     Sales Net     |     Service     |     Guestbook     |     Contact
 
After-sale service
Technical Service
 
 
 
 
 
TROUBLE SHOOTING

Before going through the checklist, check wiring connection. If any of the problems persist after check list had been made, consult your nearest service dealer.
 
Symptom Cause Solution
No power. The car ignition switch is not ON. If the power supply is properly connected to the car accessory terminal switch the ignition key to "ACC".
  The fuse is blown. Replace the fuse. Power supply voltage should be offered within the allowed range.
No sound. Volume is in minimum. Adjust volume to a desired level.
Wiring is not properly connected. Check the wiring connection.
Disc cannot be loaded or ejected. Presence of CD disc inside the player. Remove the disc in the player, and then put in the new one.
Inserting the disc in reverse direction. Insert the compact disc with the label facing upward.
Compact disc is extremely dirty or detective disc. Clean the disc or try to play a new one.
Temperature inside the car is too high. Cool off or until the ambient temperature return to normal.
Condensation Leave the player to off for an hour or so, and then try again.
LCD display error The front panel Pin and Jack is dirty. Clean the Pin and Jack with some alcohol.
The operation keys do not work. The built-in microcomputer is not operating properly due to noise. Front panel is not properly fixed into us place.
No electronic shock protection Shock exceeds 10 seconds. Press ESP key for 2 seconds to open ESP function.
Sound skips The installation angle is not more than 30 degrees. Adjust the installation angle to less than 30 degrees.
The disc is extremely dirty or defective disc.  Clean the compact discs. Then try to play a new one.
The radio does not work. The radio station automatic selection does not work. The antenna cable is not connected. Insert the antenna cable firmly.
The signals are too weak. Select a station manually.

 

CAUTION
Metal parts of this unit (especially on the back) become quite hot during operation, to be careful to careful to avoid touching parts other than the handle immediately after removing the unit.

 

 

Home  |  About Us  |  Culture  |  Products  |  Sales Net  |  Service  |  Feedback  |  Contact

Copyright (C) 2006 JIANGMEN JIABAOLI ELECTRONICS CO., LTD.